Bought these pegs because they were supposed to work with their crash bars, but only after you bought a spacer kit to make them fit (not my biggest complaint) The material is softer than sponge cake and torque the bolts made them next to impossible to keep tight. The icing on the cake though is that I dropped the bike trying to get it on the center stand and my foot slipped and it gentle rested on the crash bar, but the foot peg mount put a hole in the Valve Cover ($600.00 repair). Use your feet to run from this product not rest on them, waste of $$$$$

gets in the way of viewing the dash. needs one more ball joint use locktight to keep it from coming loose.

I bought the Krauser Engine Bars Because I liked the way they tucked in around the engine and had a place for a replaceable Slider. The went on easy, with a perfect fit. Now the astounding part, they almost completely removed the engine vibration at 5000 RPM! The first time I rode the bike after the install I thought I was in the wrong gear. I had gotten used to riding above , or below the 5000 RPM range to avoid the vibration. I couldn't believe it when I looked at the RPM and saw 5200, and it felt like I was at 6000 RPM. I put my hand on the left bar and could feel the buzz, the bar had become a vibration dampener. I had installed heaver handle bar ends, and they had helped the vibration some, but nothing like the Engine Bars! They transformed the bike.

I added the Impact Pads (Sliders) to the Engine Bars, And they really completed the package. I feel in a tip over they will save both the Bars and the Bike.

This tank pad set has the appearance and feel of exceptional quality. However, the pads only have a thin strip of adhesive material along their perimeter. After cleaning the tank surface (per the instructions), it only took two days for the side pieces to fall off. As for the center piece, the above applies with one additional note: it's not cut to the shape of the tank. If you ride an R1200RS, the center piece's thin layer of adhesive material falls across the gap between the center-line piece of the tank (grey-colored on my bike) and the side pieces (cream-colored on my bike). I returned this product and do not recommend it for any other R1200RS owner. Due to the way the review system is set up I cannot share pictures of the product, which is disappointing. Perhaps in future iterations of the site this capability will be afforded to the users.

I received these yesterday. I have a 2016 R1200R. The fit isn't perfect for this bike. I got the right one on using a couple of plastic ties to get the hook and loop to reach. The left one would cover the key for the seat so I left that on off for now. The quality seems good, but if you have a R1200R you will have to be creative when you install them.