BMW K1600 GT K1600 GTL Side Stand Enlarger

Description Instructions Reviews Video Accessories Bike Fitment

Description

Side Stand Enlarger

We have been offering side stand enlargers for BMW motorcycles for many years and we offer model specific enlargers for nearly every model since 1994. Our design is simple, easy to install and time tested. The side stand enlarger is made of machined anodized aluminum and it features a serrated edge to provide a better grip when deploying the stand.

Considering the weight of the K1600 GT and GTL, the original side stand plate at roughly 2"x 2" is on the small side to offer secure support, especially when parking on loose ground or hot asphalt. Our side stand enlarger increases the surface area by approximately 50% and provides the needed support and peace of mind. The part is precisely shaped so that there is no interference with any other part of the bike and it is also visually unobtrusive.

The three clamping screws hold the enlarger firmly in place with no drilling or other modifications needed. Be sure to place a few drops of thread locking fluid on the screws to avoid them backing out and the part falling off. We offer thread locking fluid under the Related Products.

Note: Please see the Related Products below for the optional Spike Set. The spikes not only offer additional grip with the ground, they also add some height which can reduce the amount of lean angle.

Wunderlich
35480-102

Please Note: Exceptions to model/year fitment

Model:	Starting:	Ending:	Notes:
K1600 GT	2010	2016	-2016
K1600 GTL	2010	2016	-2016

Instructions

Reviews

Star (3)
Star (0)
Star(1)
Star (0)
Star (1)

(3.8) 5 Reviews

Robert Howard

02/06/2022

Side Stand Enlarger

Increases foot print of stand, another high quality product, easy to install and looks great. You want only the best for your M/C then go with Wunderlish.

Ken

Verified Buyer

10/02/2021

Increased Shoring Surface

The product has proven to be super helpful in providing an increased shoring surface to the foot of the OEM kickstand. The smallest clearance measurement on my K1600GTL from this product (when installed) to the exhaust is 3/8" -so no issue there. Installation is straight forward and nothing has fallen off or apart during use or traveling down the road -so far, so good.

08/28/2021

Keep your bike from sinking on soft ground

I purchased the Side Stand Enlarger after a close call with my K1600GTL. I parked in a gravel parking lot and when I dismounted I noticed the bike starting to tilt as the factory side stand sunk into the ground. I haven’t parked in a soft location since installing the enlarger but the installation was easy and straight forward. It looks good on the bike and adds piece of mind. Would recommend.

CALVIN JEFFERS, Jr.

10/05/2020

Side Stand Enlarger For 2018 BMW K1600GTL

Enlarger affixes reasonably easy to side stand. It is a wee bit tricky getting the rear mounting bolt to tighten. This is because fastener is very close to side stand and the ratchet handle movement is hindered by said stand. It also "rocked" a bit due to the rubber pad affixed to the base. This rocking was eliminated as I tightened it. It is also worth mentioning that the fastener size is called out in the instructions was a metric 3 hex (too small). What worked for me was a torx 5! Once those small obstacles were overcome, all was well. I like the look. I replaced a similar enlarger that I had earlier purchased from Wunderlich that began to rust. Hopefully I will have better luck with this one.

Dwarakanath Parvatam

Verified Buyer

07/13/2018

K1600 GA Side stand enlarger

When retracted the extender is touching the exhaust shield