Description Reviews Accessories Bike Fitment

Description

Tall Handlebar

This is a great alternative to the very expensive original BMW GS handlebar. It has the nearly the same bend as the original R100 GS bar but it's about 40mm taller and 35mm longer than the original. This gives you a bit more leverage and better control. The bar has been tested and approved by the strict German TÜV.

Made in Italy by Tommaselli.

Note: This is a 22mm black bar, not a 7/8" bar. 22mm is the correct size for BMW motorcycles and though 7/8" seems close to 22mm, it's in fact slightly larger and the controls will not fit.

This handlebar is not drilled for heated grips. You can still install heated grips but you will need to drill the appropriate holes.

Reviews
Write a review

★★★★★ ★★★★★

4/5 Stars out of 2 Reviews

Write a Review

5 ★

4 ★

3 ★

2 ★

1 ★

Verified Buyer

Talk handlebars

★ ★ ★ ★ ★

Swenson (California) | May 2nd, 2023

Awesome handlebars after a lot of work to transfer heated hand grips and brush-guards. Since bars are for 1150 gs, it would easier if bar end inserts that would allow heated grip wires to thread through could be purchased. I was able to weld factory inserts into these bars. Bars will work well if only brushgaurds being transferred and bar end inserts available thru Wunderlich. Factory bar ends have to be drilled to fit larger diameter end inserts.

Items to consider

★ ★ ★

Derek Moehrle | April 13th, 2021

Installed a set of these on my '01 GS. They were almost a perfect match on height and bend. Switches and grips fit nicely with my heated grips after drilling a hole for routing. Which was mentioned in the description. The negative, factory bar ends do not fit. It needs an insert to be able to use them or the factory handguards.