BMW Oxygen Sensor Guard, Left Side, Black

Description Instructions Reviews Accessories Bike Fitment

Description

Oxygen Sensor Guard, Left Side, Black

A snapped off oxygen sensor or a torn off sensor wiring harness is a possibility when riding off road. When this happens it leads to problems with the fuel management. To add insult to injury, replacing the oxygen sensor is not cheap, and a repair is usually impossible. The Wunderlich developed sensor guard provides effective protection and ensures the oxygen sensor stays operational.

Details:

Effective protection from damage caused by stones and branches.
Reduces dirt accumulation on sensor.
Easy and simple attachment.
Fits with or without engine protection bars.

Important Fitment Information: Not compatible with Original BMW Engine protection bars.

Wunderlich
26810-202

Please Note: Exceptions to model/year fitment

Model:	Starting:	Ending:	Notes:
R nineT	2014	2016	Not with roll bars
R nineT	2017	+	Not with roll bars
R nineT Pure	2017	+	not with roll bar
R nineT Racer	2017	+	Not with roll bars
R nineT Scrambler	2017	+	Not with roll bars
R nineT Urban GS	2017	+	not with roll bar

*Installation estimated at 6 minutes for this part may vary depending on skill level.

Instructions

Reviews

Star (8)
Star (0)
Star(0)
Star (0)
Star (0)

(5) 8 Reviews

arif tuksal

03/24/2016

BEST PROTECTION AND THE LOOKS

EASY TO INSTALL AND LOOKS SUPER COOL

Dan Diener

05/01/2012

More insurance against mishaps.

I have this guard on both sides. Seems to serve its intended purpose well, looks good if you notice it tucked under there, installs in minutes. I like this part.

Dan Diener

04/07/2012

Nice part. Good fit. Easy install.

These are easy to install if you don't have any lower crash bars on your bike but that was my problem. No issues with the part. They look good if you know they are there and they appear to be very functional. I'm glad I bought them.

Sarie Arar

12/09/2011

Great Quality and Look

Easy to install, good solid quality, protection of this little piece is important against flying objects at that level. Once again, I go with the preventive measure approach. I bought the left and right side. The same was installed on my R 1200 GS 2012 model.

Sarie Arar

12/09/2011

Great Quality and Look

Jim Reynolds

05/18/2011

Ditto

If you read my review of the right side that is... Just as quick & easy to install on the left side!

Jim Reynolds

05/18/2011

No Knock?

This little guy went on in just a couple of minutes - much easier install than some competitive products I have seen (that is, I bought and returned another manufacturer's product).

Jim Reynolds

04/29/2011

O2 keep my O2 signal

These guards were very easy to install and much better than another competing set I checked into. I have one of those flex pick-up tools that I used to hold onto the inner spacer (I have the lower crash bars, for which you use a pair of spacers), this made it easier than trying to hold the spacer with my fingers while threading the bolt through it.