Part # 42742202
Frame Plug Set

Bought this set since I wanted something that would fit perfectly. Not cheap, but you get what you pay for. And if you're picky, like me, you wouldn't be disappointed with this set. I read that 2 of the top holes might not fit properly, due to a slight angle. And yes, they have a slight angle, and I was prepared to modify the plugs so they sit perfectly...but that wasn't needed at all. All plugs pushed in with my fingers (no mallet needed), and seat solid all around, including those 2 angled holes. No need to glue, or anything else. They're still solid all around. Maybe older bikes had a more pronounced angle, but if you have a 2020 or newer, you can buy this set with confidence it'd fit perfectly. Hope this helps.

I do not understand that something like this in not included on the bike. Fit perfectly clean the bike up. Well worth the money. Very high quality rubber.

The plugs really finish the look of the bike. They go in solid so there should be no issues with popping out. I'm impressed with the quality and care they came in.

Unlike the other reviewers, I had no issues with fit on my plug set. I started them in their respective hole and tapped them home with a rubber faced mallet. All plugs are well seated and very snug. Perhaps the manufacturer made some adjustments. While pricey, I'm satisfied with my purchase.

If you're like me you really hate the open frame holes on your bike. These plugs give a nice finished appearance. Of the 13 supplied, 12 fit nicely, but one, due to the angle of the frame hole, kept popping out every time I put it in. I used some glue and have my fingers crossed. I'd also prefer something fancier than just black plastic. And 13 bits of plastic should NOT cost 100 Bucks! Way too expensive. But hey, that's Wunderich for ya!

I give it four stars because one of the thirteen plugs does not fit correctly. One of the B plugs for the right side is made to fit into a flat hole, but on my 2106 R1200RS this hole is angled out and downward toward the back, so the plug does not fit correctly in the hole. The plug wants to come out at the top, a liberal use of silicone is required so that the plug is held in place, however, it should be checked often to be sure it is not lost.