Description Reviews Bike Fitment

Description

Tail Light Adapter Cable

This adapter makes fitting any aftermarket tail light much easier! This cable plugs into the stock wiring harness plug seamlessly and then allows you to make whatever connections are needed to the tail light. With this kit there will be no need to cut or otherwise modify tour original wiring harness. The adapter cable simplifies the connection of rear light units from the accessories. Sold individually.

Assignment:

Taillight = yellow cable
Brake light = red cable
License plate light = yellow
Ground (-) = black cable

Dimensions:

Female connector
Height: 3.5 mm
Width: 3.5 mm
Depth: 3.5 mm
Cable length: 100 mm

PLEASE NOTE: Some models may have different cable assignments; if that is the case, simply connect according to the original wiring

Reviews
Write a review

Currently Viewing Reviews with a rating of 4. Click here to reset.

★★★★★ ★★★★★

4.67/5 Stars out of 3 Reviews

Write a Review

5 ★

4 ★

3 ★

2 ★

1 ★

Verified Buyer

Adapter

★ ★ ★ ★

Ryan McDermott (United States) | January 2nd, 2023

To be honest I expected more, we'll call it 3.5 stars and round up, it was the correct connector and at a fair price, but the wires looked like breadboard jumpers almost and there is a gap between the heat shrink tube connection and the connector itself that I am pretty certain is a slight bit of exposed conductor. That interface where the wires meet the connector was not confidence inspiring to me. Tape and strain relief it heavily. It also wouldn't initially plug into my bike. I inspected it it looked keyed properly so I pushed just a touch hard and something clicked, a tiny piece of the face, not a keyed tab or anything the face, of my connector chipped off I'm talking immeasurably small quarter mm wide 3mm long or thereabouts. After that the plug worked fine. I used this to try and fit a Chinese tidy tail and tail light, the bike threw a light fault so I uninstalled it, no fault of this connector I am certain.